Safety Publications Tool
2022-0001 : Wings – Inner Rear Spar Trailing Edge – Modification
EASA approval number
EASA Large Aeroplanes Department
/ Type Designation
This AD supersedes EASA AD 2019-0038 dated 19 February 2019.
Publication(s) and related information
Airbus SB A380-57-8231 original issue dated 20 December 2018. Airbus SB A380-57-8274 original issue dated 16 September 2021. The use of later approved revisions of the above-mentioned documents is acceptable for compliance with the requirements of this AD.
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of Compliance for this AD. 2. This AD was posted on 24 November 2021 as PAD 21-172 for consultation until 22 December 2021. No comments were received during the consultation period. 3. Enquiries regarding this AD should be referred to the EASA Safety Information Section, Certification Directorate. E-mail: ADs[at]easa.europa.eu. 4. Information about any failures, malfunctions, defects or other occurrences, which may be similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system. This may include reporting on the same or similar components, other than those covered by the design to which this AD applies, if the same unsafe condition can exist or may develop on an aircraft with those components installed. Such components may be installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate (STC) or other modification.
EASA_AD_2022_0001.pdf (193 kb)
EASA_PAD_21_172.zip (363 kb)
For help on using this tool, please refer to
the help section
For any inquiry regarding ADs, please contact
the EASA AD team
To report any bug, broken link or problem with this application, please contact the
Disclaimer & copyright notice
- 2021 ©