Number |
2022-0009R1 |
Issued by |
Europe |
Issue date |
2022-07-19 |
Effective date |
2022-07-26 |
EASA approval number |
|
Contributor |
EASA Environment & Propulsion Systems Department |
ATA Chapter |
72 |
Approval Holder / Type Designation |
-
CFM INTERNATIONAL
-
LEAP-1A/-1C
-
LEAP-1A23
-
LEAP-1A24
-
LEAP-1A24E1
-
LEAP-1A26
-
LEAP-1A26CJ
-
LEAP-1A26E1
-
LEAP-1A29
-
LEAP-1A29CJ
-
LEAP-1A30
-
LEAP-1A32
-
LEAP-1A33
-
LEAP-1A33B2
-
LEAP-1A35A
|
Revision |
This AD revises EASA AD 2022-0009 dated 19 January 2022.
|
Correction |
Not applicable
|
Supersedure |
None
|
Publication(s) and related information |
CFM SB LEAP-1A-72-00-0461-01A-930A-D Issue 001 dated 10 December 2021, Issue 002 dated 21 December 2021 and Issue 003 dated 13 July 2022.
The use of later approved revisions of the above-mentioned document is acceptable for compliance with the requirements of this AD. |
PAD number |
21-186 |
Remarks |
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of
Compliance for this AD.
2. The original issue of this AD was posted on 22 December 2021 as PAD 21-186 for consultation until 07 January 2022. The Comment Response Documents can be found in the EASA Safety Publications Tool, in the compressed (zipped) file attached to the record for this AD.
3. Enquiries regarding this AD should be referred to the EASA Safety Information Section,
Certification Directorate. E-mail: ADs[at]easa.europa.eu.
4. Information about any failures, malfunctions, defects or other occurrences, which may be
similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system. This may include reporting on the same or similar components, other than those covered by the design to which this AD applies, if the same unsafe condition can exist or may develop on an aircraft with those components installed. Such components may be
installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate
(STC) or other modification.
|