Publication(s) and related information |
CFM SB LEAP-1B-72-00-0365-01A-930A-D issue 001 dated 25 October 2021, or issue 002 dated 22 February 2022, or issue 003 dated 26 April 2022.
CFM SB LEAP-1B-72-00-0258-01A-930A-C issue 001 dated 18 November 2019, or issue 002 dated 15 September 2020.
The use of later approved revisions of the above-mentioned documents is acceptable for compliance with the requirements of this AD. |
Remarks |
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of Compliance for this AD.
2. Based on the required actions and the compliance time, EASA have decided to issue a Final AD with Request for Comments, postponing the public consultation process until after publication.
3. Enquiries regarding this AD should be referred to the EASA Safety Information Section, Certification Directorate. E-mail: ADs[at]easa.europa.eu.
4. Information about any failures, malfunctions, defects or other occurrences, which may be similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system. This may include reporting on the same or similar components, other than those covered by the design to which this AD applies, if the same unsafe condition can exist or may develop on an aircraft with those components installed. Such components may be installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate (STC) or other modification.
|