Number |
2022-0102 |
Issued by |
Europe |
Issue date |
2022-06-08 |
Effective date |
2022-06-22 |
EASA approval number |
|
Contributor |
EASA Large Aeroplanes Department |
ATA Chapter |
05 |
Approval Holder / Type Designation |
-
AIRBUS S.A.S.
-
A318
-
A318-111
-
A318-112
-
A318-121
-
A318-122
-
A319
-
A319-111
-
A319-112
-
A319-113
-
A319-114
-
A319-115
-
A319-131
-
A319-132
-
A319-133
-
A319-151N
-
A319-153N
-
A319-171N
-
A320
-
A320-211
-
A320-212
-
A320-214
-
A320-215
-
A320-216
-
A320-231
-
A320-232
-
A320-233
-
A320-251N
-
A320-252N
-
A320-253N
-
A320-271N
-
A320-272N
-
A320-273N
-
A321
-
A321-111
-
A321-112
-
A321-131
-
A321-211
-
A321-212
-
A321-213
-
A321-231
-
A321-232
-
A321-251N
-
A321-251NX
-
A321-252N
-
A321-252NX
-
A321-253N
-
A321-253NX
-
A321-271N
-
A321-271NX
-
A321-272N
-
A321-272NX
|
Revision |
Not applicable
|
Correction |
Not applicable
|
Supersedure |
This AD supersedes EASA AD 2020-0034 dated 25 February 2020 and EASA AD 2020-0270 dated 07 December 2020.
|
Publication(s) and related information |
Airbus A318/A319/A320/A321 ALS Part 4 Revision 08 dated 02 February 2022, or Revision 08 issue 02 dated 18 February 2022.
The use of later approved variations or revisions of this document is acceptable for compliance with the requirements of this AD. |
PAD number |
22-050 |
Remarks |
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of Compliance for this AD.
2. This AD was posted on 03 May 2022 as PAD 22-050 for consultation until 31 May 2022. No comments were received during the consultation period.
3. Enquiries regarding this AD should be referred to the EASA Safety Information Section, Certification Directorate. E-mail: ADs[at]easa.europa.eu.
4. Information about any failures, malfunctions, defects or other occurrences, which may be similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system. This may include reporting on the same or similar components, other than those covered by the design to which this AD applies, if the same unsafe condition can exist or may develop on an aircraft with those components installed. Such components may be installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate (STC) or other modification.
|