Number |
2023-0008 |
Issued by |
Europe |
Issue date |
2023-01-16 |
Effective date |
2023-01-30 |
EASA approval number |
|
Contributor |
EASA Large Aeroplanes Department |
ATA Chapter |
05 |
Approval Holder / Type Designation |
-
AIRBUS S.A.S.
-
A318
-
A318-111
-
A318-112
-
A318-121
-
A318-122
-
A319
-
A319-111
-
A319-112
-
A319-113
-
A319-114
-
A319-115
-
A319-131
-
A319-132
-
A319-133
-
A319-151N
-
A319-153N
-
A319-171N
-
A320
-
A320-211
-
A320-212
-
A320-214
-
A320-215
-
A320-216
-
A320-231
-
A320-232
-
A320-233
-
A320-251N
-
A320-252N
-
A320-253N
-
A320-271N
-
A320-272N
-
A320-273N
-
A321
-
A321-111
-
A321-112
-
A321-131
-
A321-211
-
A321-212
-
A321-213
-
A321-231
-
A321-232
-
A321-251N
-
A321-251NX
-
A321-252N
-
A321-252NX
-
A321-253N
-
A321-253NX
-
A321-271N
-
A321-271NX
-
A321-272N
-
A321-272NX
|
Revision |
Not applicable
|
Correction |
Not applicable
|
Supersedure |
None
|
Publication(s) and related information |
Airbus A318/A319/A320/A321 ALS Part 2 Variation 9.2 dated 10 November 2022.
The use of later approved revisions of the above-mentioned document, or of an ALS revision which includes the technical content of the Variation, is acceptable for compliance with the requirements of this AD. |
PAD number |
22-161 |
Remarks |
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of
Compliance for this AD.
2. This AD was posted on 23 November 2022 as PAD 22-161 for consultation until 21 December 2022. The Comment Response Document can be found in the EASA Safety Publications Tool, in the compressed (zipped) file attached to the record for this AD.
3. Enquiries regarding this AD should be referred to the EASA Safety Information Section,
Certification Directorate. E-mail: ADs[at]easa.europa.eu.
4. Information about any failures, malfunctions, defects or other occurrences, which may be
similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on
a product, part or appliance not affected by this AD, can be reported to the EU aviation safety
reporting system. This may include reporting on the same or similar components, other than
those covered by the design to which this AD applies, if the same unsafe condition can exist or
may develop on an aircraft with those components installed. Such components may be
installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate
(STC) or other modification.
|