Number |
2023-0009 |
Issued by |
Europe |
Issue date |
2023-01-16 |
Effective date |
2023-01-30 |
EASA approval number |
|
Contributor |
EASA Large Aeroplanes Department |
ATA Chapter |
53 |
Approval Holder / Type Designation |
-
AIRBUS S.A.S.
-
A318
-
A318-111
-
A318-112
-
A318-121
-
A318-122
-
A319
-
A319-111
-
A319-112
-
A319-113
-
A319-114
-
A319-115
-
A319-131
-
A319-132
-
A319-133
-
A320
-
A320-211
-
A320-212
-
A320-214
-
A320-215
-
A320-216
-
A320-231
-
A320-232
-
A320-233
-
A321
-
A321-111
-
A321-112
-
A321-131
-
A321-211
-
A321-212
-
A321-213
-
A321-231
-
A321-232
|
Revision |
Not applicable
|
Correction |
Not applicable
|
Supersedure |
This AD supersedes EASA AD 2019-0173 dated 18 July 2019.
|
Publication(s) and related information |
Airbus SB A320-53-1402 original issue dated 17 May 2018, or Revision 01 dated 12 February 2021, or Revision 02 dated 03 March 2022.
Airbus SB A320-53-1403 original issue dated 17 May 2018, or Revision 01 dated 12 February 2021, or Revision 02 dated 28 February 2022.
Airbus SB A320-53-1404 original issue dated 17 May 2018, or Revision 01 dated 12 February 2021.
Airbus SB A320-53-1405 original issue dated 17 May 2018, or Revision 01 dated 12 February 2021.
Airbus SB A320-53-1406 original issue dated 17 May 2018, or Revision 01 dated 12 February 2021.
Airbus SB A320-53-1407 original issue dated 17 May 2018, or Revision 01 dated 12 February 2021.
The use of later approved revisions of the above-mentioned documents is acceptable for
compliance with the requirements of this AD. |
PAD number |
22-129 |
Remarks |
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of
Compliance for this AD.
2. This AD was posted on 27 September 2022 as PAD 22-129 for consultation until 25 October
2022. The Comment Response Document can be found in the EASA Safety Publications Tool, in
the compressed (zipped) file attached to the record for this AD.
3. Enquiries regarding this AD should be referred to the EASA Safety Information Section,
Certification Directorate. E-mail: ADs[at]easa.europa.eu.
4. Information about any failures, malfunctions, defects or other occurrences, which may be
similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system. This may include reporting on the same or similar components, other than those covered by the design to which this AD applies, if the same unsafe condition can exist or may develop on an aircraft with those components installed. Such components may be
installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate
(STC) or other modification.
|