Number |
2023-0060 |
Issued by |
Europe |
Issue date |
2023-03-16 |
Effective date |
2023-03-30 |
EASA approval number |
|
Contributor |
EASA General Aviation Department |
ATA Chapter |
05 |
Approval Holder / Type Designation |
-
DASSAULT AVIATION
-
Fan Jet Falcon
-
Fan Jet Falcon
-
Fan Jet Falcon C
-
Fan Jet Falcon D
-
Fan Jet Falcon E
-
Fan Jet Falcon F
|
Revision |
Not applicable
|
Correction |
Not applicable
|
Supersedure |
This AD supersedes EASA AD 2019-0141 dated 17 June 2019.
|
Publication(s) and related information |
Dassault FJF AMM ALS Chapter 5-40 (DGT131028) Revision 19 dated April 2022.
Dassault FJF SB 730 original issue 23 February 1990, or Revision 1 dated 12 December 1990.
The use of later approved revisions of the above-mentioned documents is acceptable for
compliance with the requirements of this AD. |
PAD number |
23-022 |
Remarks |
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of Compliance for this AD.
2. This AD was posted on 15 February 2023 as PAD 23-022 for consultation until 15 March 2023. No comments were received during the consultation period.
3. Enquiries regarding this AD should be referred to the EASA Safety Information Section, Certification Directorate. E-mail: ADs[at]easa.europa.eu.
4. Information about any failures, malfunctions, defects or other occurrences, which may be similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system. This may include reporting on the same or similar components, other than those covered by the design to which this AD applies, if the same unsafe condition can exist or may develop on an aircraft with those components installed. Such components may be installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate (STC) or other modification.
|