Number |
2023-0100 |
Issued by |
Europe |
Issue date |
2023-05-11 |
Effective date |
2023-05-25 |
EASA approval number |
|
Contributor |
EASA General Aviation Department |
ATA Chapter |
05 |
Approval Holder / Type Designation |
|
Revision |
Not applicable
|
Correction |
Not applicable
|
Supersedure |
This AD supersedes EASA AD 2022-0136 dated 06 July 2022.
|
Publication(s) and related information |
Dassault Falcon 2000EX AMM, Chapter 5-40 (DGT 113877), ALS, Revision 15 dated November 2022.
The use of later approved revisions of the above-mentioned document is acceptable for compliance with the requirements of this AD. |
PAD number |
23-045 |
Remarks |
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of Compliance for this AD.
2. This AD was posted on 12 April 2023 as PAD 23-045 for consultation until 10 May 2023. No comments were received during the consultation period.
3. Enquiries regarding this AD should be referred to the EASA Safety Information Section, Certification Directorate. E-mail: ADs[at]easa.europa.eu.
4. Information about any failures, malfunctions, defects or other occurrences, which may be similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system. This may include reporting on the same or similar components, other than those covered by the design to which this AD applies, if the same unsafe condition can exist or may develop on an aircraft with those components installed. Such components may be installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate (STC) or other modification.
|