Safety Publications Tool
22-119 : Hot Air Balloons – Connection Load Strap / Suspension Cable – Inspection / Modification
Please feel free to send us your comments by email at
ADs [at] easa.europa [dot] eu
EASA approval number
EASA General Aviation Department
/ Type Designation
CS SERIES HOT AIR BALLOONS
JZ SERIES HOT AIR BALLOONS
JZX SERIES HOT AIR BALLOONS
This AD supersedes DGAC France AD F-2004-136 (EASA approval 2004-8259) dated 18 August 2004, which replaced DGAC France Emergency AD UF-2004-136 dated 29 July 2004.
Publication(s) and related information
Ballons Chaize SB 5 original issue (Version 01_0) dated 05 July 2022. The use of later approved revisions of the above-mentioned document is acceptable for compliance with the requirements of this AD.
1. This Proposed AD will be closed for consultation on 22 September 2022. 2. Enquiries regarding this PAD should be referred to the EASA Safety Information Section, Certification Directorate. E-mail: ADs[at]easa.europa.eu. 3. Information about any failures, malfunctions, defects or other occurrences, which may be similar to the unsafe condition addressed by this PAD, and which may occur, or have occurred on a product, part or appliance not affected by this PAD, can be reported to the EU aviation safety reporting system. This may include reporting on the same or similar components, other than those covered by the design to which this PAD applies, if the same unsafe condition can exist or may develop on an aircraft with those components installed. Such components may be installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate (STC) or other modification.
EASA_PAD_22_119.pdf (191 kb)
For help on using this tool, please refer to
the help section
For any inquiry regarding ADs, please contact
the EASA AD team
To report any bug, broken link or problem with this application, please contact the
Disclaimer & copyright notice
- 2021 ©