Safety Publications Tool
2013-0084R1 : Landing Gear - Main Landing Gear Lever Hinge Fitting - Inspection
EASA approval number
EASA General Aviation Department
/ Type Designation
This AD revises EASA AD 2013-0084 dated 05 April 2013.
Publication(s) and related information
Piaggio SB 80-0345 at original issue, dated 20 September 2012. SLS SB P180-32-33 original issue, dated 12 September 2018. The use of later approved revisions of the above-mentioned documents is acceptable for compliance with the requirements of this AD.
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of Compliance for this AD. 2. The original issue of this AD was posted on 27 February 2013 as PAD 13-038 for consultation until 26 March 2013. No comments were received during the consultation period. 3. Enquiries regarding this AD should be referred to the EASA Safety Information Section, Certification Directorate. E-mail: ADs[at]easa.europa.eu. 4. Information about any failures, malfunctions, defects or other occurrences, which may be similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system. This may include reporting on the same or similar components, other than those covered by the design to which this AD applies, if the same unsafe condition can exist or may develop on an aircraft with those components installed. Such components may be installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate (STC) or other modification.
EASA_AD_2013_0084_R1.pdf (208 kb)
easa_pad_13_038.zip (821 kb)
For help on using this tool, please refer to
the help section
For any inquiry regarding ADs, please contact
the EASA AD team
To report any bug, broken link or problem with this application, please contact the
Disclaimer & copyright notice
- 2021 ©