Safety Publications Tool
leading to the decision not to take AD action similar to Federal Aviation Administration (FAA) AD 2019-24-01
leading to the decision not to take AD action similar to Federal Aviation Administration (FAA) AD 2020-01-15
2018-0211 : SUPERSEDED BY EASA AD 2019-0018
EASA approval number
EASA Propulsion Section
/ Type Designation
This AD supersedes EASA AD 2018-0109 dated 17 May 2018.
Publication(s) and related information
CFM International S.A. CFM56-7B S/B 72-1019 original issue dated 24 March 2017, or Revision 01 dated 13 June 2017. CFM International S.A. CFM56-7B S/B 72-1024 original issue dated 26 July 2017. CFM International S.A. CFM56-7B S/B 72-1033 original issue dated 20 April 2018, or Revision 01 dated 09 May 2018, or Revision 02 dated 27 July 2018. CFM International S.A. ESM Revision 54 Incremental Change, or Revision 55. The use of later approved revisions of the above-mentioned documents is acceptable for compliance with the requirements of this AD.
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of Compliance for this AD. 2. This AD was posted on 17 August 2018 as PAD 18-117 for consultation until 14 September 2018. The Comment Response Document can be found in the EASA Safety Publications Tool, in the compressed (zipped) file attached to the record for this AD. 3. Enquiries regarding this AD should be referred to the EASA Safety Information Section, Certification Directorate. E-mail: ADs[at]easa.europa.eu. 4. Information about any failures, malfunctions, defects or other occurrences, which may be similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system.
EASA_AD_2018_0211_superseded.pdf (556 kb)
EASA_PAD_18_117_-_Superseded.zip (2 mb)
For help on using this tool, please refer to
the help section
For any inquiry regarding ADs, please contact
the EASA AD team
To report any bug, broken link or problem with this application, please contact the
Disclaimer & copyright notice
- 2006 ©