| Number |
2020-0138 |
| Issued by |
 Europe |
| Issue date |
2020-06-19 |
| Effective date |
2020-07-03 |
| EASA approval number |
|
| Contributor |
EASA General Aviation Department |
| ATA Chapter |
27 |
Approval Holder
/ Type Designation |
-
B/E AEROSPACE FISCHER GmbH
-
ASTIR CS TOP
-
ASTIR CS 77 TOP
-
ASTIR CS Jeans TOP
-
ASTIR CS TOP
-
FIBERGLAS TECHNIK R. LINDNER
-
Grob Sailplanes
-
ASTIR CS
-
ASTIR CS 77
-
ASTIR CS Jeans
-
CLUB ASTIR II
-
GROB G 103 A TWIN II ACRO
-
GROB G 103 C TWIN III
-
GROB G 103 C TWIN III ACRO
-
GROB G 103 C TWIN III SL
-
GROB G 103 TWIN II
-
STANDARD ASTIR II
-
TWIN ASTIR
-
TWIN ASTIR TRAINER
|
| Revision |
Not applicable
|
| Correction |
Not applicable
|
| Supersedure |
This AD supersedes EASA AD 2020-0121 dated 28 May 2020.
|
| Publication(s) and related information |
Fiberglas-Technik TM-G09/SB-G09 original issue dated 08 April 2020, or Revision 1 dated 14 May 2020.
Fiberglas-Technik A/I-G09 original issue dated 08 April 2020, or Revision 1 dated 14 May 2020.
The use of later approved revisions of the above-mentioned documents is acceptable for compliance with the requirements of this AD. |
| Remarks |
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of Compliance for this AD.
2. Based on the required actions and the compliance time, EASA have decided to issue a Final AD with Request for Comments, postponing the public consultation process until after publication.
3. Enquiries regarding this AD should be referred to the EASA Programming and Continued Airworthiness Information Section, Certification Directorate. E-mail: ADs[at]easa.europa.eu.
4. Information about any failures, malfunctions, defects or other occurrences, which may be similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system.
|
