Safety Publications Tool
2020-0199 : [Correction] Rotors Flight Control – Main Rotor Scissors Fittings – Inspection
EASA approval number
EASA VTOL Department
/ Type Designation
This AD has been republished to correct the P/N of the affected part.
Publication(s) and related information
HG SB 20-011 Revision B dated 01 September 2020. HG SB 20-012 Revision A (original issue) dated 01 September 2020. The use of later approved revisions of the above-mentioned documents is acceptable for compliance with the requirements of this AD.
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of Compliance for this AD. 2. Based on the required actions and the compliance time, EASA have decided to issue a Final AD with Request for Comments, postponing the public consultation process until after publication. 3. Enquiries regarding this AD should be referred to the EASA Programming and Continued Airworthiness Information Section, Certification Directorate. E-mail: ADs[at]easa.europa.eu. 4. Information about any failures, malfunctions, defects or other occurrences, which may be similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system. This may include reporting on the same or similar components, other than those covered by the design to which this AD applies, if the same unsafe condition can exist or may develop on an aircraft with those components installed. Such components may be installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate (STC) or other modification.
EASA_AD_2020_0199_C1.pdf (569 kb)
EASA_AD_2020_0199.zip (2 mb)
For help on using this tool, please refer to
the help section
For any inquiry regarding ADs, please contact
the EASA AD team
To report any bug, broken link or problem with this application, please contact the
Disclaimer & copyright notice
- 2021 ©