| Number |
2020-0278 |
| Issued by |
 Europe |
| Issue date |
2020-12-14 |
| Effective date |
2020-12-28 |
| EASA approval number |
|
| Contributor |
EASA General Aviation Department |
| ATA Chapter |
05 |
Approval Holder
/ Type Designation |
|
| Revision |
Not applicable
|
| Correction |
Not applicable
|
| Supersedure |
This AD supersedes EASA AD 2020-0120 dated 27 May 2020.
|
| Publication(s) and related information |
Pilatus PC-6 ALS Document Number 02334, issue 10 dated 30 October 2020.
Pilatus PC-6 AMM, Chapter 04-00-00, Document Number 01975, issue 30 dated 30 October 2020.
Pilatus PC-6 AMM, Chapter 04-00-00, Document Number 01975 (IAC AR), issue 30 dated
30 October 2020 (approved by EASA on behalf of the Interstate Aviation Committee for aeroplanes
registered in the Commonwealth of Independent States).
The use of later approved revisions of the above-mentioned documents is acceptable for
compliance with the requirements of this AD. |
| PAD number |
20-188 |
| Remarks |
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of Compliance for this AD.
2. This AD was posted on 26 November 2020 as PAD 20-188 for consultation until 10 December 2020. No comments were received during the consultation period.
3. Enquiries regarding this AD should be referred to the EASA Programming and Continued Airworthiness Information Section, Certification Directorate. E-mail: ADs[at]easa.europa.eu.
4. Information about any failures, malfunctions, defects or other occurrences, which may be similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system. This may include reporting on the same or similar components, other than those covered by the design to which this AD applies, if the same unsafe condition can exist or may develop on an aircraft with those components installed. Such components may be installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate (STC) or other modification.
|
