Safety Publications Tool
2021-0102 : Flight Controls – Elevator Mass Balance and Balance Fittings – Inspection / Replacement
EASA approval number
EASA General Aviation & VTOL Department
/ Type Designation
AVO 68 (Samburo)
AVO 68-R 100
AVO 68-R 115
This AD supersedes EASA AD 2018-0219 dated 12 October 2018.
Publication(s) and related information
M&D Flugzeugbau GmbH MSB 808-18 Revision 04 dated 10 October 2018. M&D Flugzeugbau GmbH MSB 808-33 original issue dated 17 February 2021. The use of later approved revisions of the above-mentioned documents is acceptable for compliance with the requirements of this AD.
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of Compliance for this AD. 2. This AD was posted on 09 March 2021 as PAD 21-038 for consultation until 06 April 2021. No comments were received during the consultation period. 3. Enquiries regarding this AD should be referred to the EASA Safety Information Section, Certification Directorate. E-mail: ADs@easa.europa.eu. 4. Information about any failures, malfunctions, defects or other occurrences, which may be similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system. This may include reporting on the same or similar components, other than those covered by the design to which this AD applies, if the same unsafe condition can exist or may develop on an aircraft with those components installed. Such components may be installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate (STC) or other modification.
EASA_AD_2021_0102.pdf (203 kb)
EASA_PAD_21_038.zip (385 kb)
For help on using this tool, please refer to
the help section
For any inquiry regarding ADs, please contact
the EASA AD team
To report any bug, broken link or problem with this application, please contact the
Disclaimer & copyright notice
- 2021 ©