| Number |
2021-0166R1 |
| Issued by |
 Europe |
| Issue date |
2022-12-22 |
| Effective date |
2022-12-29 |
| EASA approval number |
|
| ATA Chapter |
25 |
Approval Holder
/ Type Designation |
-
AIRBUS S.A.S.
-
A320
-
A320-214
-
A320-251N
-
A320-271N
|
| Revision |
This AD revises EASA AD 2021-0166 dated 13 July 2021, including its Correction dated 30 July 2022.
|
| Correction |
Not applicable
|
| Supersedure |
None
|
| Publication(s) and related information |
Airbus SB A320-25-1BQH original issue dated 03 July 2019, or Revision 01 dated 21 October 2020, or Revision 02 dated 14 March 2022.
Airbus SB A320-25-1BQG original issue dated 03 July 2019, or Revision 01 dated 21 October 2020, or Revision 02 dated 28 June 2021, or Revision 03 dated 14 March 2022.
The use of later approved revisions of the above-mentioned documents is acceptable for
compliance with the requirements of this AD. |
| PAD number |
21-075 |
| Remarks |
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of
Compliance for this AD.
2. The original issue of this AD was posted on 21 May 2021 as PAD 21-075 for consultation until 18 June 2021. The Comment Response Document can be found in the EASA Safety Publications Tool, in the compressed (zipped) file attached to the record for this AD.
3. Enquiries regarding this AD should be referred to the EASA Safety Information Section,
Certification Directorate. E-mail: ADs[at]easa.europa.eu.
4. Information about any failures, malfunctions, defects or other occurrences, which may be
similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on
a product, part or appliance not affected by this AD, can be reported to the EU aviation safety
reporting system. This may include reporting on the same or similar components, other than
those covered by the design to which this AD applies, if the same unsafe condition can exist or
may develop on an aircraft with those components installed. Such components may be
installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate
(STC) or other modification.
|
