| Number |
2021-0191-E |
| Issued by |
 Europe |
| Issue date |
2021-08-20 |
| Effective date |
2021-08-20 |
| EASA approval number |
|
| ATA Chapter |
|
Approval Holder
/ Type Designation |
|
| Revision |
Not applicable
|
| Correction |
This AD is republished to correct Table 1 which referred to fuel pumps instead of oil pumps.
|
| Supersedure |
This AD supersedes EASA Emergency AD 2021-0143-E dated 16 June 2021.
|
| Publication(s) and related information |
Austro Engine SB MSB-E4-031 original issue dated 14 June 2021, or Revision 1 dated 01 July 2021, or
Revision 2 dated 21 July 2021.
The use of later approved revisions of the above-mentioned document is acceptable for compliance
with the requirements of this AD. |
| Remarks |
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of
Compliance for this AD.
2. The results of the safety assessment have indicated the need for immediate publication and
notification, without the full consultation process.
3. Enquiries regarding this AD should be referred to the EASA Safety Information Section,
Certification Directorate. E-mail: ADs[at]easa.europa.eu.
4. Information about any failures, malfunctions, defects or other occurrences, which may be
similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on
a product, part or appliance not affected by this AD, can be reported to the EU aviation safety
reporting system. This may include reporting on the same or similar components, other than
those covered by the design to which this AD applies, if the same unsafe condition can exist or
may develop on an aircraft with those components installed. Such components may be
installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate
(STC) or other modification.
|
