Number |
2021-0217R1 |
Issued by |
Europe |
Issue date |
2024-03-08 |
Effective date |
2024-03-22 |
EASA approval number |
|
ATA Chapter |
05 |
Approval Holder / Type Designation |
-
ROLLS-ROYCE DEUTSCHLAND Ltd & Co KG
-
TRENT XWB
-
Trent XWB-75
-
Trent XWB-79
-
Trent XWB-79B
-
Trent XWB-84
|
Revision |
This AD revises EASA AD 2021-0217 dated 23 September 2021.
|
Correction |
Not applicable
|
Supersedure |
The original issue of this AD superseded EASA AD 2020-0066 dated 23 March 2020.
|
Publication(s) and related information |
Rolls-Royce Trent XWB TLM TRENTXWB-K0680-TIME0-01, version 49 dated 01 May 2021, Modules "Airworthiness Limitations (Mandatory Parts Lives)" TRENTXWB-A-05-10-01-00A01-030A-D and Modules "Airworthiness Limitations (Mandatory Inspections)" TRENTXWB-A-05-20-01-00A01-030A-D.
The use of later approved revisions of the above-mentioned document is acceptable for compliance with the requirements of this AD. |
PAD number |
21-130 |
Remarks |
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of Compliance for this AD.
2. The original issue of this AD was posted on 25 August 2021 as PAD 21-130 for consultation until 22 September 2021. No comments were received during the consultation period.
3. Enquiries regarding this AD should be referred to the EASA Safety Information Section, Certification Directorate. E-mail: ADs[at]easa.europa.eu.
4. Information about any failures, malfunctions, defects or other occurrences, which may be similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system. This may include reporting on the same or similar components, other than those covered by the design to which this AD applies, if the same unsafe condition can exist or may develop on an aircraft with those components installed. Such components may be installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate (STC) or other modification.
|