| Number |
2021-0243 |
| Issued by |
 Europe |
| Issue date |
2021-11-08 |
| Effective date |
2021-11-22 |
| EASA approval number |
|
| Contributor |
EASA General Aviation Department |
| ATA Chapter |
32 |
Approval Holder
/ Type Designation |
|
| Revision |
Not applicable
|
| Correction |
Not applicable
|
| Supersedure |
None
|
| Publication(s) and related information |
M&D Flugzeugbau GmbH & Co. KG SB-MD10-007 original issue dated 11 March 2021, or Rev. 1
dated 10 May 2021, or Rev. 2 dated 13 September 2021.
M&D Flugzeugbau GmbH & Co. KG WOI MD10-WOI-32-001 original issue dated 11 March 2021, or Rev. 00a dated 07 June 2021.
The use of later approved revisions of the above-mentioned documents is acceptable for
compliance with the requirements of this AD. |
| PAD number |
21-143 |
| Remarks |
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of
Compliance for this AD.
2. This AD was posted on 08 October 2021 as PAD 21-143 for consultation until 05 November
2021. No comments were received during the consultation period.
3. Enquiries regarding this AD should be referred to the EASA Safety Information Section,
Certification Directorate. E-mail: ADs[at]easa.europa.eu.
4. Information about any failures, malfunctions, defects or other occurrences, which may be
similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system. This may include reporting on the same or similar components, other than those covered by the design to which this AD applies, if the same unsafe condition can exist or may develop on an aircraft with those components installed. Such components may be
installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate
(STC) or other modification.
|
