| Number |
2022-0071 |
| Issued by |
 Europe |
| Issue date |
2022-04-26 |
| Effective date |
2022-05-10 |
| EASA approval number |
|
| ATA Chapter |
05 |
Approval Holder
/ Type Designation |
-
CFM INTERNATIONAL
-
LEAP-1B
-
LEAP-1B21
-
LEAP-1B23
-
LEAP-1B25
-
LEAP-1B27
-
LEAP-1B28
-
LEAP-1B28B1
-
LEAP-1B28B2
-
LEAP-1B28B2C
-
LEAP-1B28B3
-
LEAP-1B28BBJ1
-
LEAP-1B28BBJ2
|
| Revision |
Not applicable
|
| Correction |
Not applicable
|
| Supersedure |
This AD supersedes EASA AD 2020-0055 dated 11 March 2020.
|
| Publication(s) and related information |
CFM LEAP-1B ESM SM.21, Chapter 05, currently at Revision 019, data modules as listed in Appendix 1 of this AD.
CFM SB LEAP-1B-72-00-0342-01A-930A-D Issue 002 dated 26 July 2021.
The use of later approved revisions of the above-mentioned documents is acceptable for compliance with the requirements of this AD. |
| PAD number |
22-012 |
| Remarks |
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of Compliance for this AD.
2. This AD was posted on 15 February 2022 as PAD 22-012 for consultation until 15 March 2022. The Comment Response Documents can be found in the EASA Safety Publications Tool, in the compressed (zipped) file attached to the record for this AD.
3. Enquiries regarding this AD should be referred to the EASA Safety Information Section, Certification Directorate. E-mail: ADs[at]easa.europa.eu.
4. Information about any failures, malfunctions, defects or other occurrences, which may be similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system. This may include reporting on the same or similar components, other than those covered by the design to which this AD applies, if the same unsafe condition can exist or may develop on an aircraft with those components installed. Such components may be installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate (STC) or other modification.
|
