| Number |
2024-0009 |
| Issued by |
 Europe |
| Issue date |
2024-01-09 |
| Effective date |
2024-01-23 |
| EASA approval number |
|
| ATA Chapter |
05 |
Approval Holder
/ Type Designation |
-
AIRBUS S.A.S.
-
A300-600
-
A300B4-601
-
A300B4-603
-
A300B4-605R
-
A300B4-620
-
A300B4-622
-
A300B4-622R
-
A300C4-605R variant F
-
A300C4-620
-
A300F4-605R
-
A300F4-622R
|
| Revision |
Not applicable
|
| Correction |
Not applicable
|
| Supersedure |
This AD supersedes EASA AD 2019-0090 dated 26 April 2019, EASA AD 2020-0111R2 dated 16 June 2020, EASA AD 2021-0093 dated 30 March 2021, EASA AD 2021-0204 dated 14 September 2021, EASA AD 2021-0258 dated 17 November 2021, EASA AD 2022-0192 dated 23 September 2022 and EASA AD 2023-0091 dated 05 May 2023.
|
| Publication(s) and related information |
Airbus A300-600 ALS Part 2 DT-ALI Revision 04 dated 20 July 2023.
The use of later approved variations or revisions of the above-mentioned document is acceptable for compliance with the requirements of this AD. |
| PAD number |
23-138 |
| Remarks |
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of
Compliance for this AD.
2. This AD was posted on 05 December 2023 as PAD 23-138 for consultation until 02 January
2024. No comments were received during the consultation period.
3. Enquiries regarding this AD should be referred to the EASA Safety Information Section,
Certification Directorate. E-mail: ADs[at]easa.europa.eu.
4. Information about any failures, malfunctions, defects or other occurrences, which may be
similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on
a product, part or appliance not affected by this AD, can be reported to the EU aviation safety
reporting system. This may include reporting on the same or similar components, other than
those covered by the design to which this AD applies, if the same unsafe condition can exist or
may develop on an aircraft with those components installed. Such components may be
installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate
(STC) or other modification.
|
