You are not logged in
  Safety Publications Tool

2024-0100 : Equipment and Furnishings / Ice and Rain Protection / Fuselage – Dual Hoist Removable Parts or De-icing System – Removal

Number 2024-0100
Issued by Europe  Europe
Issue date 2024-05-10
Effective date 2024-05-24
EASA approval number
Contributor EASA VTOL Department
ATA Chapter 25 / 30 / 53
Approval Holder
/ Type Designation
  • AIRBUS HELICOPTERS
    • SA 330 / AS 332 / EC 225
      • AS 332 C
      • AS 332 C1
      • AS 332 L
      • AS 332 L1
Revision Not applicable
Correction Not applicable
Supersedure This AD supersedes EASA AD 2018-0142R1 dated 09 December 2019.
Publication(s) and related information Ref. Publications: AH AS332 Emergency ASB 01.00.91 original issue dated 03 July 2018, or Revision 1 dated 04 December 2019. AH AS332 Emergency ASB 01.00.96 original issue dated 04 December 2019. AH ASB AS332-04-00-0001 original issue dated 27 March 2024. The use of later approved revisions of above-mentioned documents is acceptable for compliance with the requirements of this AD.
Remarks 1. If requested and appropriately substantiated, EASA can approve Alternative Methods of Compliance for this AD. 2. This AD was posted on 09 April 2024 as PAD 24-042 for consultation until 07 May 2024. No comments were received during the consultation period. 3. Enquiries regarding this AD should be referred to the EASA Safety Information Section, Certification Directorate. E-mail: ADs [at] easa.europa.eu. 4. Information about any failures, malfunctions, defects or other occurrences, which may be similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system. This may include reporting on the same or similar components, other than those covered by the design to which this AD applies, if the same unsafe condition can exist or may develop on an aircraft with those components installed. Such components may be installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate (STC) or other modification.