| Number |
2025-0090 |
| Issued by |
 Europe |
| Issue date |
2025-04-23 |
| Effective date |
2025-05-07 |
| EASA approval number |
|
| ATA Chapter |
04 |
Approval Holder
/ Type Designation |
-
LEONARDO S.p.A. HELICOPTERS
|
| Revision |
Not applicable
|
| Correction |
Not applicable
|
| Supersedure |
This AD supersedes EASA AD 2023-0161 dated 16 August 2023.
|
| Publication(s) and related information |
Leonardo AW189 document 89-A-AMPI-00-P (Air Vehicle Maintenance Planning Information),
Chapter 04, ALS Issue 028 dated 31 May 2024.
Leonardo AW189 document 89-E-AMPI-00-P (Air Vehicle Maintenance Planning Information),
Chapter 04, ALS Issue 012 dated 31 May 2024.
The use of later approved revisions of the above-mentioned documents is acceptable for
compliance with the requirements of this AD. |
| PAD number |
25-054 |
| Remarks |
1. If requested and appropriately substantiated, EASA can approve Alternative Methods of Compliance for this AD.
2. This AD was posted on 25 March 2025 as PAD 25-054 for consultation until 22 April 2025. No comments were received during the consultation period.
3. Enquiries regarding this AD should be referred to the EASA Safety Information Section, Certification Directorate. E-mail: ADs[at]easa.europa.eu.
4. Information about any failures, malfunctions, defects or other occurrences, which may be similar to the unsafe condition addressed by this AD, and which may occur, or have occurred on a product, part or appliance not affected by this AD, can be reported to the EU aviation safety reporting system. This may include reporting on the same or similar components, other than those covered by the design to which this AD applies, if the same unsafe condition can exist or may develop on an aircraft with those components installed. Such components may be installed under an FAA Parts Manufacturer Approval (PMA), Supplemental Type Certificate (STC) or other modification.
|
